Tuesday, April 21, 2015

Apr 20 - Shimmed bearing mount

I got the bearing mount for the intermediate shaft shimmed to where it is no longer in a bind.  I can turn the shaft by hand pretty smoothly now.  I did 2 washers up top and one washer down low to get the angle just right.  I'll trial fit it again before final torque for assembly once the transmission comes off once more and goes back on for the starter relocation.

Here's a couple of pics of the shaft and its mount.

I'll tidy up the plug wires one day.  When it gets closer to time for when it will matter.  :-)

No comments:

Post a Comment